Installing A Power-Supply Paddle Card In The System-Board Tray - IBM x iDataPlex dx340 Series Problem Determination And Service Manual

Installing a power-supply paddle card in the system-board tray

To install a power-supply paddle card in the system-board tray, complete the
following steps.
1. Touch the static-protective package that contains the power-supply paddle card
2. Place the power-supply paddle card on the mounting studs in the system-board
3. Reconnect the power-supply paddle card cables.
4. Install the 3.5-inch simple-swap drives, if you removed any. Complete the
5. Install the DIMMs, if you removed any (see "Installing a memory module" on
6. Install the expansion enclosure, if you removed one (see "Installing an
7. Install the system-board tray in the chassis (see "Installing the system-board
150
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide
to any unpainted metal surface on the outside of the system-board tray; then,
remove the power-supply paddle card from the package.
tray and install the four screws.
following steps:
a. Install the hard disk drive bracket and cable assembly (see "Removing and
installing a one-bay or four-bay hard disk drive bracket and cable assembly"
on page 108).
b. Reconnect the hard disk drive bracket and cable assembly cables.
c. Install the 3.5-inch hard disk drive (see "Installing a 3.5-inch simple-swap
hard disk drive" on page 91).
page 107).
expansion enclosure on a system-board tray" on page 74); otherwise, install the
system-board tray cover (see "Installing the system-board tray cover" on page
122).
tray in a 2U chassis" on page 76 or "Installing the system-board tray in a 3U
chassis" on page 78).
Power-supply
paddle card
System-board tray