Installing The 3U Chassis Fan Assembly - IBM x iDataPlex dx340 Series Problem Determination And Service Manual

Installing the 3U chassis fan assembly

To install the 3U chassis fan assembly, complete the following steps.
1. Touch the static-protective package that contains the fan assembly to any
2. Orient the fan assembly over the opening in the chassis. Make sure that the
3. Lower the fan assembly into the chassis and press down on the tab above the
4. Install the retention bracket.
5. Install the top cover (see "Installing the 2U chassis top cover" on page 83).
6. Install the 3U chassis in the iDataPlex rack (see "Installing the 3U chassis top
3U chassis
unpainted metal surface on the outside of the chassis; then, remove the fan
assembly from the package.
power connector on the fan assembly aligns with the connector on the power
supply.
power connector and make sure that it is fully seated.
cover" on page 85).
Retention
bracket
Chapter 4. Removing and replacing server components
Fan assembly
99