Removing And Replacing Tier 2 Crus; Removing The Management Card - IBM Flex System p270 Compute Node Installation And Service Manual

1. Follow any special handling and installation instructions that come with the battery.
2. Tilt the battery so that you can insert it into the socket. Make sure that the side with the positive (+)
symbol is facing the correct direction.
3. Press the battery toward the outer wall of the compute node chassis until fully inserted into the
battery holder.
4. Install and close the compute node cover. See "Installing and closing the compute node cover" on
page 34.
Statement 21
CAUTION:
Hazardous energy is present when the compute node is connected to the power source. Always
replace the compute node cover before you install the compute node.
5. Install the compute node into the IBM Flex System Enterprise Chassis. See "Installing the compute
node in an IBM Flex System Enterprise Chassis" on page 92.
6. Turn on the compute node and reset the system date and time through the operating system that you
installed. For additional information, see your operating-system documentation.
7. Ensure that the system time is correct in each of the logical partitions. For additional information, see
the documentation for your operating system.
8. If you replaced the part because of a service action, verify the repair by checking that the amber
enclosure fault LED is off. For more information, see "Compute node control panel button and LEDs"
on page 9.

Removing and replacing tier 2 CRUs

Use this information for removing and replacing tier 2 CRUs.
About this task
You can install a tier 2 CRU, or you can request IBM to install it, at no additional charge, under the type
of warranty service that is designated for the compute node.

Removing the management card

You can remove this tier 2 CRU, or you can request IBM to remove it, at no additional charge, under the
type of warranty service that is designated for the compute node. Remove the management card to
replace the card or to reuse the card in a new system-board and chassis assembly.
58
Power Systems: IBM Flex System p270 Compute Node Installation and Service Guide