Removing The Pcie Adapter Bay Cover - IBM x iDataPlex dx340 Series Problem Determination And Service Manual

Removing the PCIe adapter bay cover

To remove the adapter bay cover from the I/O enclosure, complete the following
steps.
I/O enclosure
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
3. Remove the I/O enclosure (see "Removing an expansion enclosure from a
4. Carefully set the I/O enclosure on a flat, static-protective surface.
5. Remove the two screws that secure the PCIe adapter bay cover to the I/O
6. Slide the PCIe adapter bay cover out of the mounting tabs and remove it from
7. If you are instructed to return the PCIe adapter bay cover, follow all packaging
PCI slots
PCIe bay cover
on page 71.
system-board tray from a 2U chassis" on page 75 or "Removing the
system-board tray from a 3U chassis" on page 77).
system-board tray" on page 73).
enclosure and save the screws for future use.
the I/O enclosure.
instructions, and use any packaging materials for shipping that are supplied to
you.
Slot cover
Tabs
End of
Bay cover
Adapter
Screws
Chapter 4. Removing and replacing server components
113