Removing The Power Cord - IBM x iDataPlex dx340 Series Problem Determination And Service Manual

Removing the power cord

To remove the power cord, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the 2U chassis or 3U chassis is installed in an iDataPlex rack, remove the
3. Unplug the power cord that you are working on from the PDU.
4. Use an M3 hex driver to remove the two screws from the rail and set them
5. Pull the mounting plate and power cord toward the front of the rack cabinet.
6. Separate the power cord from the mounting plate; then, set the mounting plate
7. If you are instructed to return the power cord, follow all packaging instructions,
92
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide
Mounting
plate
Mounting
post
on page 71.
chassis from the rack (see "Removing the 2U chassis from a Type 7825
iDataPlex rack" on page 123) or (see "Removing a 3U chassis from a Type
7825 iDataPlex rack" on page 129).
aside.
aside.
and use any packaging materials for shipping that are supplied to you.
Plug
mount
Power
cord mounting
bracket
M3
screws
Power
cord