Removing The Management Card - IBM BladeCenter JS22 Problem Determination And Service Manual

10. Insert the DIMM by pressing the DIMM along the guides into the connector.
11. Install and close the blade server cover. See "Installing and closing the blade
12. Install the blade server into the BladeCenter unit. See "Installing the blade

Removing the management card

Remove the management card to replace the card or to reuse the card in a new
system board and chassis assembly.
250
JS22 Type 7998: Problem Determination and Service Guide
4. Carefully lay the blade server on a flat, static-protective surface, with the
cover side up.
5. Open and remove the blade server cover. See "Removing the blade server
cover" on page 242.
6. Locate the DIMM connectors on the system board. See the illustration in
"System-board connectors" on page 9. Determine the connector into which
you will install the DIMM.
7. Touch the static-protective package that contains the part to any unpainted
metal surface on the BladeCenter unit or any unpainted metal surface on any
other grounded rack component; then, remove the part from its package.
8. Verify that both of the connector retaining clips are in the fully open position.
9. Turn the DIMM so that the DIMM keys align correctly with the connector on
the system board.
Attention: To avoid breaking the DIMM retaining clips or damaging the
DIMM connectors, handle the clips gently.
Verify that each retaining clip snaps into the closed position.
Important: If there is a gap between the DIMM and the retaining clips, the
DIMM is not correctly installed. Open the retaining clips to remove and
reinsert the DIMM.
server cover" on page 243.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade server cover before installing the
blade server.
server in a BladeCenter unit" on page 240.