IBM x iDataPlex dx340 Series Problem Determination And Service Manual page 128

Installing a four-bay hard disk drive bracket and cable assembly
To install a four-bay hard disk drive bracket and cable assembly in the storage
enclosure, complete the following steps.
Storage
enclosure
1. Touch the static-protective package that contains the hard disk drive bracket
2. Place the hard disk drive bracket and cable assembly on the mounting tabs
3. Reconnect the hard disk drive bracket and cable assembly cables.
4. Install the hard disk drives, if you removed any from the storage enclosure (see
5. Install the storage enclosure (see "Installing an expansion enclosure on a
6. Install the system-board tray in the chassis (see "Installing the system-board
112
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide
Release latch
and cable assembly to any unpainted metal surface on the outside of the
storage enclosure; then, remove the hard disk drive bracket and cable assembly
from the package.
inside the storage enclosure; then, press down on the hard disk drive bracket
and cable assembly until the release latches click into place.
"Installing a 3.5-inch simple-swap hard disk drive" on page 91).
system-board tray" on page 74).
tray in a 2U chassis" on page 76).
Hard disk drive bracket
and cable assembly
Release latch