Table of Contents
Advertisement
Removing a front-panel assembly
To remove the front-panel assembly, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
3. If an expansion enclosure is installed, remove it (see "Removing an expansion
4. If DIMMs are installed in DIMM slot 30 or slot 31, remove the DIMMs (see
5. Note the cable routing and where each cable is connected and disconnect the
6. Press the release tab and slide the front-panel assembly away from the front of
7. Note the cable routing and disconnect the front-panel assembly cables from the
8. Open the cable retention latches and carefully pull the assembly and cables
9. If you are instructed to return the front-panel assembly, follow all packaging
on page 71.
system-board tray from a 2U chassis" on page 75 or "Removing the
system-board tray from a 3U chassis" on page 77).
enclosure from a system-board tray" on page 73); otherwise, remove the
system-board tray cover (see "Removing the system-board tray cover" on page
121).
"Removing a memory module" on page 106). To identify the DIMM connectors,
see "System-board connectors" on page 7.
cables located around the front-panel assembly to improve accessibility.
the system-board tray.
system board and power-supply paddle card.
from the system-board tray.
instructions, and use any packaging materials for shipping that are supplied to
you.
Chapter 4. Removing and replacing server components
135
Advertisement
Table of Contents
