Table of Contents
Advertisement
Important
Caution
Be sure to turn off the power to
the unit and all peripherals as
well as unplug the power from
the unit before adding or
removing devices.
Connecting a mass storage device
Besides the mass storage device connected to the mini SATA connector, you can
connect an additional mass storage device (such as a hard disk drive or solid-state
drive (SSD)), using the SATA 7-pin connector.
❖ Matrox 4Sight GPm only supplies 5 V of power to its SATA power connector.
Therefore, storage devices requiring a 12 V supply are not supported.
To install a mass storage device in the Matrox 4Sight GPm unit, perform the
following:
1. Unplug the power supply from your unit.
2. Remove the chassis cover. To see instructions on how to do so, refer to Removing
the Matrox 4Sight GPm chassis cover section, earlier in this chapter.
3. Place the SATA hard disk drive against the chassis cover, so that the drive's
connector is closest to the serial number on the base plate (as depicted below).
Connecting a mass storage device
53
Advertisement
Table of Contents
