Table of Contents
Advertisement
56 Chapter 3: Adding devices to Matrox 4Sight GPm
4. Press the board down until the board clicks into place.
Note that the clasps should spring back to their original position and firmly
❖
hold the board in place. If the clasps do not spring back over the mini board,
or the mini board seems loose, try pushing the clasps into place or sliding the
mini board back towards the clasps. When the clasps fall into the proper
position, there is a single metallic click.
Clasp
Good position
5. Once the board is seated, reassemble the case.
6. Reconnect the power to your unit.
Note that, unlike the 7-pin SATA hard disk drive, the mSATA and mini PCIe
❖
boards draw their power directly through the motherboard.
7. After your Matrox 4Sight GPm boots, run the BIOS Setup program to verify that
the mass storage device is identified correctly.
Clasp
Bad position
Advertisement
Table of Contents
