Table of Contents
Advertisement
Important
Installing mini boards
Two types of mini boards can be installed on your Matrox 4Sight GPm unit's
motherboard. Both the mini PCIe and mSATA (mini SATA) boards have the same
form factor (dimensions of 51mm x 30 mm), but will only work in the appropriate
slot. Your unit provides a Gen2 x1 PCIe interface for the mini PCIe board.
To install a mini PCIe and/or mSATA board in the Matrox 4Sight GPm unit,
perform the following:
1. Unplug the power supply from your unit.
2. Remove the chassis cover. To see instructions on how to do so, refer to Removing
the Matrox 4Sight GPm chassis cover section, earlier in this chapter.
3. Slip the edge of the mini PCIe or mSATA board into its appropriate connector.
The connecting edge will fit neatly into the socket, leaving the board at a 20 degree
angle from the motherboard.
Caution
Be sure to turn off the power to
the unit and all peripherals as
well as unplug the power from
the unit before adding or
removing devices.
Note that a mini PCIe board and an mSATA board will fit in each other's
❖
connector; but will only work if they are in their own connector.
connector
Installing mini boards
mini board
55
Advertisement
Table of Contents
