Connecting A Mass Storage Device - Matrox 4Sight EV6 Installation And Hardware Reference

54 Chapter 3: Adding devices to Matrox 4Sight EV6
Important

Connecting a mass storage device

Besides the mass storage device connected to the M.2 connector, you can connect
up to two additional mass storage devices (such as a hard disk drive (HDD) or
solid-state drive (SSD)), using the SATA 7-pin connectors.
 Matrox 4Sight EV6 only supplies 5 V of power to its SATA power connector.
Therefore, storage devices requiring a 12 V supply are not supported.
To install additional mass storage devices in the Matrox 4Sight EV6 unit, perform
the following:
1. Unplug the power supply from your unit.
2. Remove the chassis cover. To see instructions on how to do so, refer to Removing
the Matrox 4Sight EV6 chassis cover section, earlier in this chapter.
3. Two brackets are provided for the addition of one or 2 mass storage devices. Screw
each bracket halfway to both sides of one of the mass storage devices. It is best to
install these brackets even if you don't plan on using a second mass storage device,
so that they are not misplaced.
If you are attaching a second mass storage device, do not screw the first mass storage
device to the brackets all the way yet.