Table of Contents
Advertisement
Item
Options
Max TOLUD
Dynamic*
1 GB
1.25 GB
1.5 GB
1.75 GB
2 GB
2.25 GB
2.5 GB
2.75 GB
3.0 GB
3.25 GB
SATA Port 0 time out (MS)
0*
1 to 65535
Power Over Ethernet
Disabled*
Enabled
Power Over Ethernet Port 1
Disabled*
Enabled
Power Over Ethernet Port 2
Disabled*
Enabled
Power Over Ethernet Port 3
Disabled*
Enabled
Power Over Ethernet port 4
Disabled*
Enabled
Meaning
This item allows you to set the maximum value of TOLUD. TOLUD is the amount of RAM below the PCI
memory-mapped range. The higher TOLUD is, the more RAM is available to the operating system, if the
operating system is a 32-bit operating system.
By selecting Dynamic, TOLUD automatically adjusts, based on the memory range reserved for I/0 devices in
the chipset's integrated graphics controller. Selecting Dynamic allows the operating system to access the
most RAM possible (up to 4 Gbytes). This is the recommended setting.
If your operating system is a 32-bit operating system, and if you set Max TOLUD below the amount of MIL
non-paged reserved memory, you will encounter problems.
The version of Windows Embedded Standard installed on Matrox 4Sight GPm is a 64-bit operating system;
therefore, Max TOLUD will not affect MIL reserved memory.
This item allows you to add a maximum delay, in msec, to SATA Port 0.
This item should not be changed.
❖
This item allows you to enable Power Over Ethernet (PoE) for the four Ethernet ports that support it.
The following precautions should be taken whenever using PoE ports or peripherals:
• Make sure that your Matrox 4Sight GPm unit is turned off prior to connecting or disconnecting any PoE
peripherals, such as a camera.
• Enable Power over Ethernet (PoE) only on the ports that require it. If a peripheral does not require power
from the Ethernet cable, keep PoE disabled on that board through the BIOS.
This item allows you to enable Power Over Ethernet (PoE) for port 1.
This item is only available when Power Over Ethernet is set to Enabled.
This item allows you to enable Power Over Ethernet (PoE) for port 2.
This item is only available when Power Over Ethernet is set to Enabled.
This item allows you to enable Power Over Ethernet (PoE) for port 3.
This item is only available when Power Over Ethernet is set to Enabled.
This item allows you to enable Power Over Ethernet (PoE) for port 4.
This item is only available when Power Over Ethernet is set to Enabled.
Advanced menu
103
Advertisement
Table of Contents
