Table of Contents
Advertisement
26 Chapter 2: Getting started with your Matrox 4Sight GPm unit
Operating your Matrox 4Sight GPm for the
first time
Perform the following steps to operate Matrox 4Sight GPm for the first time:
1. If necessary, connect the power connector latch to the power supply cable's open
wires. Refer to the Making your own open-wire power supply cable subsection, later
in this chapter.
2. Connect the power connector latch (attached to the power supply cable) to the
unit's power connector.
Use the screws on the sides of the power connector latch to secure it in place. Note
that the power connector latch will only fit into the unit's power connector in the
following way:
Matrox 4Sight GPm unit front
Power connector latch
Screws
3. Connect your display device, USB keyboard, and USB mouse to the unit.
For more information on how to connect and configure these devices, refer to the
Connecting video output display devices section and the Connecting a device sections,
later in this chapter.
-
+
Power connector
Advertisement
Table of Contents
