Networking Connections - Matrox 4Sight GPm Installation And Hardware Reference

Required cabling
for Ethernet
connections

Networking connections

You can connect Matrox 4Sight GPm to your local area network (LAN). To do
so, connect a network cable to one of the Gigabit Ethernet connectors, located on
the back panel of the chassis.
Matrox 4Sight GPm can gain access to a LAN via Gigabit Ethernet (1000 BaseT),
Fast Ethernet (100 BaseT), or Twisted Pair Ethernet (10 BaseT) through one of
the Gigabit Ethernet connectors.
If you plan to use Gigabit Ethernet, use a Category 5e (CAT5e) cable. If you plan
to use Fast Ethernet, use a Twisted Pair Category 5 (UTP5) cable. If you plan to
use Twisted Pair Ethernet, use a UTP5 or UTP3 cable.
An RJ45 connector (shown below) must be attached to each end of the cable.
Networking connections 33