Table of Contents
Advertisement
Warning
DC power connector
The DC power connector is a terminal-block connector. It is shown below with
the single x3 mating connector attached to the chassis.
The positive (+) and negative (-) wire terminal slots must be connected for the
device to be powered.
Pin/Connector
Purpose
Chassis ground.
-
Ground (- power).
+
Power.
To ensure EMC conformity, connect the chassis ground pin of your Matrox 4Sight
GPm unit to earth.
Back panel connectors
There are the following connectors on the back panel:
- USB 3.0 connectors. There are 4 on the Matrox 4Sight GPm (Ivy Bridge) and
1 on the Matrox 4Sight GPm (Bay Trail).
- Two USB 2.0 connectors.
- Gigabit Ethernet connectors with PoE support. There are 4 on the
Matrox 4Sight GPm (Ivy Bridge) and 2 on the Matrox 4Sight GPm (Bay Trail).
- Gigabit Ethernet connectors. There are 2 on the Matrox 4Sight GPm (Ivy
Bridge) and 1 on the Matrox 4Sight GPm (Bay Trail).
- One DVI-I connector and one DVI-D connector.
Pinout descriptions of external connectors
Connecting wire color
Black
Red
77
Advertisement
Table of Contents
