Table of Contents
Advertisement
Warning
3. Apply the tip of your soldering iron to each wire for a second; then, apply solder
to the wire. The solder should flow freely onto the wire and coat it. Clean off any
excess solder, if necessary.
4. Connect the exposed ends of your power supply cable into the power connector
latch. To do so, push the red wire into the positive (+) wire-terminal slot and the
black wire into the negative (-) wire-terminal slot. Connect the chassis ground pin
(
to earth ground.
)
To ensure EMC conformity, connect the chassis ground pin of your Matrox 4Sight
GPm unit to earth.
5. Secure the wires into their wire-terminal slots by tightening the screw associated
with the wire, at the bottom of the power connector latch.
Power connector latch
Bottom
6. Return to the Operating your Matrox 4Sight GPm for the first time section for
instruction in how to connect the power connector latch into the power connector
of your unit.
Making your own open-wire power supply cable
Bottom
-
+
- +
Screws to tighten
the wires in-place.
29
o
Advertisement
Table of Contents
