Table of Contents
Advertisement
Important
Caution
4. Plug the power cable into a DC supply.
5. Turn the unit on using the power button on the front panel.
6. Once the unit boots, use the presented drop-down menu to select your language.
Note that, after selecting the language, you must reinstall the operating system to
change the language.
❖ Note that Matrox 4Sight GPm assumes that your keyboard language is the same
as the language you selected.
7. Verify that your connected devices are operating correctly.
Once your devices are operational, you can power down the unit to connect more
devices to the motherboard, networking interface, or connect devices to the
auxiliary I/O interface. For information on adding hardware to the
Matrox 4Sight GPm motherboard, refer to Chapter 3: Adding devices to
Matrox 4Sight GPm. For information on connecting devices to the auxiliary I/O
interface, refer to the Connecting to the auxiliary I/O interface section, later in this
chapter.
Turning off the Matrox 4Sight GPm unit
To turn off the Matrox 4Sight GPm unit, press the power button. You can also
shut down the unit by shutting down Windows with the Shut Down command.
If the unit does not respond to the above methods, push and hold the power button
until the unit shuts down.
Be sure to turn off the power to the unit and all peripherals, as well as unplug the
power from the unit before adding or removing devices.
Rebooting the unit
When the unit is on, you can reboot the unit using one of the two following
techniques:
• Press the Control-Alt-Delete keys on your keyboard simultaneously.
• Press the power button to turn the unit off, and then press the power button to
turn the unit on again.
Operating your Matrox 4Sight GPm for the first time
27
Advertisement
Table of Contents
