Table of Contents
Advertisement
SATA connector for mass storage devices
The SATA connector is a 7-pin male connector. It is used to connect a mass storage
device. The pinout for the SATA connector is available at the website of the Serial
ATA International Organization, http://www.sata-io.org.
The mass storage device should be mounted to the chassis cover. For more
information, refer to the Connecting a mass storage device section, in Chapter 3:
Adding devices to Matrox 4Sight GPm.
SATA power for mass storage device
The SATA power connector is a 4-pin connector. It is used to power a mass storage
device. The pinout for the SATA power connector is available at the website of
the Serial ATA International Organization, http://www.sata-io.org.
❖ Matrox 4Sight GPm only supplies 5 V of power to its SATA power connector.
Therefore, storage devices requiring a 12 V supply are not supported.
The mass storage device should be mounted to the chassis cover. For more
information, refer to the Connecting a mass storage device section, in Chapter 3:
Adding devices to Matrox 4Sight GPm.
Recovery connector
The recovery connector is a grouping of 2-pin standard, 2.54 mm, male
connectors. It can force a hardware-reset of the CMOS, BIOS, and real-time clock.
❖ Note that the recovery connector should not be used unless you are directed to
do so from Matrox Technical support.
Jumper
Installed on Pins 1-2
Installed on Pins 3-4
Installed on Pins 5-6
Installed on Pins 7-8
1. Pin 1 is marked with a white arrow on the motherboard. The arrow's direction indicates that pin 2 is directly beside pin 1.
Pinout descriptions of internal connectors
Description
1
Clear CMOS.
Clear real-time clock
BIOS recovery
Reserved.
85
Advertisement
Table of Contents
