Console Redirection Setup Submenu - Matrox 4Sight GPm Installation And Hardware Reference

142 Appendix D: Matrox 4Sight GPm (Bay Trail) BIOS reference
Item
Options
SATA Speed
Gen1
Gen2*
Serial ATA Port 0 Connected to an ODD
Serial ATA Port 1 Connected to an ODD
Item
Options
Console Serial Redirect
Enabled
Disabled*
Terminal Type
VT_100*
VT_100+
VT_UTF8
PC_ANSI
Meaning
This item allows you to configure the speed of the SATA device.
By selecting Gen1, the SATA device will transfer data at the speed of a Gen 1 SATA device.
By selecting Gen2, the SATA device will transfer data at the speed of a Gen 2 SATA device.
Note that this item should not be changed.
❖
These items set If there is a SATA device connected to an optical disk drive.The BIOS will detect the
media's insertion and ejection.
Port 0 is associated with the SATA connector.
Port 1 is associated with the mSATA connector.

Console Redirection Setup submenu

The Console Redirection Setup submenu allows you to configure the
communication between the unit (via a serial port) and your remote computer's
terminal-emulation program. Console redirection allows you to control the unit
from a remote display and keyboard (such as, a computer connected to your unit
via its serial port).
❖ Note that the settings of your terminal-emulation program running on your
remote computer must match the following console serial redirection settings to
facilitate communication with your unit.
Meaning
This item allows you to enable console redirection from/to a serial port while in the BIOS setup utility.
By selecting Enabled, the display and keyboard will be redirected from/to a serial port.
By selecting Disabled, the display and keyboard will not be redirected from/to a serial port.
This item allows you to set the terminal type to emulate.
This item is only visible when Console Serial Redirect is set to Enabled.
❖