5. Maintenance and conversion
• The new single-part flat seal is no longer glued to the
Fig. 5/5: Flat seal
• Place the end cover on the connecting lugs of the
• Tighten the screws of the electrical connector plate in
– CPV valve terminals with CP connection and relay
• Fit the plugs onto the relay outputs as described
CPV... 9811d
bottom of the electrical sub-base, but simply placed
on the connecting lugs of the valve solenoid coils
(see diagram).
New flat seal
valve block. Carefully press down the end cover.
diagonally
opposite
(CPV10/14) or with 3 Nm (CPV18).
plates
under "Connecting current-consuming devices to the
relay plate."
sequence
with
0.6 Nm
5-11