Festo CPV -VI Series Manual page 90

5. Maintenance and conversion
PLEASE NOTE
– To equip the CPV10 Valve Terminal with "F valve
– Note that only CPV valve terminals with a CP
• Only CPV10/14 valve terminals: Check that the seals
Pneumatic spring valve (Ident code M):
Designation "L" on the seal
must point forwards.
The flat seal for valve plates with 3/2-way
valves (Ident code C, H and N) as well as
for all end plates is symmetrical and marked
with 3/2.
Fig. 5/3: Position and designation of seals with pneumatic spring valves or
double solenoid valves (only CPV10/14 valve terminals)
5-8
plates" (Ident. code F), please note the assembly
and application references in the "System Overview"
chapter under "Valve Plate Overview".
connector can be assembled with relay plates
(Ident. code R).
are seated correctly when valve plates with pneu-
matic springs or double solenoid valves are fitted.
The seating is not symmetrical (see diagram).
Double solenoid valve (Ident code J):
Designation "J" on the seal must point
forwards.
CPV... 9811d