Festo CPV -VI Series Manual page 39

2. Fitting
Proceed as follows:
• Make sure that the fastening surface can support the
• Fit one of the following hat rails:
• Make sure that there is enough room to connect the
• Fasten the hat rail to the surface approximately every
• Screw the 2 brackets onto the end plates with the
CPV... 9811d
weight of the CPV valve terminal.
Hat rail for CPV10/14 terminal
Support rail as per
EN 50022 - 35 x 7.5
(width 35 mm, height 7.5 mm)
power cables and the pneumatic tubing.
100 mm.
screws supplied, as shown in the diagram below.
With the CPV10/14 valve terminals, make sure that
the fixing bolts of the brackets grip into the recess in
the CPV valve terminal.
CP terminal Self-cutting screws
CPV10/14
CPV18
Hat rail for CPV18 terminal
Support rail as per
EN 50022 - 35 x 15
(width 35 mm, height 15 mm)
Tightening torque
M4 x 10 1.5 Nm
M5 x 10 4 Nm
2-9