3. Installation
CPV valve terminal with individual connection
With this CPV valve terminal variant each valve sole-
noid coil is connected separately.
PLEASE NOTE
• Use only the following pre-assembled Festo
– KMYZ-3-24-...-LED / KMYZ-5-24-...-LED. An LED is
– KMYZ-4-24-... .This socket offers a low-cost
Address assignment of the valves
• The addresses must be assigned in ascending order
• A valve location always occupies two addresses
• Counting begins from left to right, on the individual
Fig. 3/7: Address assignment of the CPV valve terminal
3-14
connecting sockets for connecting the valve
solenoid coils.
incorporated in the transparent plugs of each of
these connecting sockets. The LED indicates the
switching status of the valve solenoid coil.
alternative. There is no LED in the plug, but
it complies with protection class IP40.
without gaps
(even if it is occupied by a reserve, isolating or relay
plate)
valve plates from the front to the rear (see Fig. 3/7)
with IC connection and 8 valve locations
CPV... 9811d