7. Attach the temperature probe connector to the main circuit board. The temperature
probe connects to the main circuit board at J18, located to the lower right of the
battery (see
8. Replace the autosampler cover (see
717plus
Cover) and reconnect the power cord.
2.6.3 Installing the Large Sample Loop
To inject sample volumes greater than 200 µL, you must install the auxiliary loop.
Caution:
To avoid the possibility of electric shock, disconnect the autosampler power
cord before continuing this procedure.
Required tools:
• One 5/16-inch wrench
• One adjustable wrench
Carousel Drive
Temperature Probe
Figure 2-10 Installing the Temperature Probe
Figure
2-9).
Section 2.6.1, Removing/Replacing the
2
Installation
52