Sending Analog And Digital Content; Configuring Content Display With People+Content Ip - Polycom HDX 4000 Series Administrator's Manual

Sending Analog and Digital Content

Configuring Content Display with People+Content IP

Polycom, Inc.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Do one of the following:
3
— In the local interface, go to System > Admin Settings > Network >
Call Preference (select
— In the web interface, go to Admin Settings > Network > Call
Preference.
Enable H.239.
4
You cannot enable or disable H.239 while in a call.
Do one of the following:
5
— In the local interface, go to System > Admin Settings > Audio >
Inputs/Outputs (select
— In the web interface, go to Admin Settings > Network > Audio.
Set the Content Input Level (not available on the Polycom HDX 9002 or
6
Polycom HDX 9001 systems).
If you have one content input on an HDX system connected to both an analog
source (VGA) and digital source (DVI) using a break-out cable, the HDX
system gives the digital source precedence when sending content. To send
content from the analog source, disconnect both sources, wait 10 seconds, and
then reconnect the analog source only.
People+Content IP enables a presenter to show content from a computer to
other sites in a video conference using only an IP network connection. The
presenter can show PowerPoint
type of content from a computer. People+Content IP supports any computer
desktop resolution with color set to 16-bit or higher.
People+Content IP is unavailable when your Security Profile is set to Maximum.
Before a presenter can use a computer to show content with
People+Content IP, you need to:
Content and Closed Captions
if necessary).
if necessary).
®
slides, video clips, spreadsheets, or any other
5–5