Otto Bock C-Brace Instructions For Use Manual page 56

from to Press top but­
LOM 1st
LOM 2nd
INFORMATION
If 4 short beep signals are emitted, this means switching could not be completed. The most fre­
quent cause of this is that the weight was not taken off the leg after the first beep signal.
7.4.2 Activating the additional mode (2nd mode)
INFORMATION
Before the first step, always check whether the selected mode corresponds to the desired
motion type.
1) Press and hold the lower button ( ).
→ A long beep signal is emitted.
2) Take weight off the leg
→ Two short beep signals sound to indicate successful switching to the additional mode
(2nd mode).
INFORMATION: If four beep signals sound, the weight was not taken off the leg
correctly or for long enough. Repeat the process to correctly switch to the desired
mode.
7.4.3 Activating LOM
From basic mode (1st mode) to LOM:
► Briefly press the lower button ( ) twice.
→ Three short beep signals are emitted.
→ The product has successfully switched to LOM.
From additional mode (2nd mode) to LOM:
1) Briefly press the lower button ( ) twice.
→ A long beep signal is emitted.
2) Take weight off the leg .
→ Three short beep signals are emitted.
→ The product has successfully switched to LOM.
INFORMATION
LOM is automatically deactivated by switching to basic mode (1st mode) or the additional mode
(2nd mode).
7.4.4 Switching from an additional mode back to basic mode
1) Press and hold the upper button ( ).
→ A long beep signal is emitted.
2) Take weight off the leg
56
Press bottom
ton ( ) button ( )
1 x long
1 x long
and keep it still for approx. 1 second.
and keep it still for approx. 1 second.
Beep sig­ Additional
nal action
1 x long Relieve load on
1 x long Relieve load on
Beep sig­
nal
1 x short
leg
2 x short
leg