The Base Fits Over Three Pre-Drilled Holes; Position The Touchscreen Mount Over The Three Pre-Drilled Holes - Thermo Scientific Nicolet Summit User Manual

Thermo Scientific
2. Remove the WiFi compartment cover from the back of the spectrometer.
While standing in front of the spectrometer, gently squeeze the left side of the cover and
lift the cover up and off of the spectrometer, as shown in Figure 1. This cover can be
discarded or stored for future use.
Figure 4. Gently squeeze the left side of the cover and lift it off of the spectrometer
3. Install the touchscreen monitor.
The base of the touchscreen mount attaches to the spectrometer with three captive screws,
as shown in Figure 2.
Figure 5.

The base fits over three pre-drilled holes

a. Guide the front bottom of the mount into the compartment and then rotate the
mount past the sides of the compartment, as shown in Figure 3.
Figure 6.

Position the touchscreen mount over the three pre-drilled holes

Install the Touchscreen Monitor
Nicolet Summit User Guide 63