Thermo Scientific Nicolet Summit User Manual page 71

Thermo Scientific
5. Install the new cover and turn on the spectrometer.
a. Insert the tabs on the cover's right edge into the slots in front of the touchscreen
mount, and then lower the cover over the cables and press the cover down until it
snaps into place. There should be only a thin, uniform gap between the covers.
Figure 11. Position the cover around the touchscreen mount first, then lower it into place
WARNING To ensure a good ground connection and avoid shock hazard, do not
use an outlet that is connected to a conduit ground. The ground must be a
noncurrent-carrying wire connected to earth ground at the main distribution
box.
b. Plug in and power on the spectrometer.
c. To turn on the touchscreen, press the power button on the rear side of the monitor.
Congratulations. Your touchscreen monitor is installed and ready for use. With the
touchscreen monitor installed, you can open OMNIC Paradigm software and switch to the
touchscreen interface for a convenient, streamlined experience.
Install the Touchscreen Monitor
Nicolet Summit User Guide 67