Thermo Scientific Nicolet Summit User Manual page 68

Thermo Scientific
b. Using the 9/64-inch hex driver, begin tightening each of the three captive screws to
ensure that the mount is aligned over the holes. Once each screw is started, finish
tightening all of the screws until they are snug. You may have to rotate the screen out
of the way to access each screw.
Figure 7. Rotate the screen out of the way if it is blocking access to the captive screws
4. Connect and position the three cables.
The touchscreen monitor connects to the spectrometer with three cables: an HDMI
cable, a USB cable, and the power cable. We recommend routing the cables in the
sequence described below to ensure that the cover sits properly over the cables.
Install the Touchscreen Monitor
Nicolet Summit User Guide 64