Thermo Scientific Nicolet Summit User Manual
Hide thumbs Also See for Nicolet Summit:

Advertisement

Quick Links

Thermo Scientific
Install the touchscreen monitor to save space in your lab and to take full advantage of
OMNIC Paradigm software for touchscreen for quickly executing workflows and carrying out
routine procedures.

Tools and Materials Needed

• Touchscreen monitor installation kit
• Touchscreen monitor, with mount
• New WiFi compartment cover with notch
• 9/64-inch hex driver
Time needed: 25 minutes or less
To install the touchscreen monitor

1. Prepare the spectrometer.

a. Press the power button to turn off the spectrometer and then unplug the power cord.
b. Turn off the purge, if applicable, and disconnect the purge line to the instrument and
any accessory.
c. Remove any accessory from the sample compartment.
Nicolet Summit User Guide
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Nicolet Summit and is the answer not in the manual?

Questions and answers

Summary of Contents for Thermo Scientific Nicolet Summit

  • Page 1 Press the power button to turn off the spectrometer and then unplug the power cord. b. Turn off the purge, if applicable, and disconnect the purge line to the instrument and any accessory. c. Remove any accessory from the sample compartment. Thermo Scientific Nicolet Summit User Guide...
  • Page 2 Guide the front bottom of the mount into the compartment and then rotate the mount past the sides of the compartment, as shown in Figure 3. Figure 3. Position the touchscreen mount over the three pre-drilled holes Nicolet Summit User Guide Thermo Scientific...
  • Page 3 The touchscreen monitor connects to the spectrometer with three cables: an HDMI cable, a USB cable, and the power cable. We recommend routing the cables in the sequence described below to ensure that the cover sits properly over the cables. Thermo Scientific Nicolet Summit User Guide...
  • Page 4 Figure 6. It may be easier to roll the cable into place rather than pushing it. Figure 6. Tuck the extra length of HDMI cable in front of the touchscreen mount Nicolet Summit User Guide Thermo Scientific...
  • Page 5 Figure 7. The three cables fit in the cable guides along the back of the spectrometer 1. HDMI cable 2. Heat sink fins Thermo Scientific Nicolet Summit User Guide...
  • Page 6 Congratulations. Your touchscreen monitor is installed and ready for use. With the touchscreen monitor installed, you can open OMNIC Paradigm software and switch to the touchscreen interface for a convenient, streamlined experience. © 2019 Thermo Fisher Scientific Inc. All rights reserved. 269-334400_Revison A Nicolet Summit User Guide Thermo Scientific...

Table of Contents