Table of Contents
Advertisement
NOTE:
Push the black card holder to hold the card in the riser.
Figure 89. Closing the card holder on the expansion card riser
Next steps
1. If applicable, connect the cables to the expansion card.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.
Optional serial COM port
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1.
Lift the expansion card riser
2. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your system
Safety instructions
Before working inside your system
and disconnect the serial COM port cable from the connector on the rear I/O board.
on page 26.
on page 25.
on page 26.
Installing and removing system components
93
Advertisement
Table of Contents
