Table of Contents
Advertisement
Figure 102. Installing GPU on Riser 3 and Riser 4
Next steps
1. If removed,
install the GPU air shroud
2.
Install the GPU air shroud top
3.
Install the full length expansion card
4. Follow the procedure listed in
5. Install any device drivers required for the card as described in the documentation for the card.
Optional serial COM port
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove expansion card
4. Disconnect the serial COM port cable from the connector on the rear I/O board.
Steps
1. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
144
Installing and removing system components
.
cover.
riser.
After working inside your system
Safety instructions
Before working inside your system
riser.
on page 47.
on page 46.
on page 47.
Advertisement
Table of Contents
