Figure 25. Removing the drive from the drive carrier
Next steps
1.
Replace the drive into the drive
Installing the drive into the drive carrier
Prerequisites
1.
Remove the front
bezel.
NOTE:
When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.
Steps
1. Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
3. Using a Phillips #1 screwdriver, tighten the screws that secure the drive to the drive carrier.
Figure 26. Installing a drive into the drive carrier
carrier.
Installing and removing system components
51