Removing An Expansion Card Riser - Dell EMC PowerEdge R640 Installation And Service Manual

Card type
1Gb NICs (Broadcom)
1Gb NICs (Intel)
External RAID (Dell design)
Integrated RAID (Dell design)
rNDC (Broadcom)
rNDC (Intel)
rNDC (Mellanox)
rNDC (QLogic)

Removing an expansion card riser

Prerequisites
Follow the safety guidelines listed in
Follow the procedure listed in
Before removing the expansion card riser 2A, remove the expansion card from the riser, if installed.
Disconnect any cables connected to the expansion card.
Steps
Hold the touch points, and lift the expansion card riser, from the riser connector, on the system board.
NOTE: While removing the riser 1B, press the tabs and hold the touch point to lift the expansion card riser from the
system board.
Figure 62. Removing the expansion riser 1B
114 Installing and removing system components
Slot priority
1, 2
1, 2
1, 2
Integrated Slot
Integrated Slot
Integrated Slot
Integrated Slot
Integrated Slot
Safety instructions.
Before working inside your system.
Form factor
Low Profile
Low Profile
Low Profile
NONE
NONE
NONE
NONE
NONE