Installing the front bezel
The procedure to install the front bezel with and without the LCD panel is the same.
Prerequisites
Follow the safety guidelines listed in
Steps
Locate and remove the bezel key.
NOTE:
The bezel key is part of the LCD bezel package.
Align and insert the right end of the bezel onto the system.
Press the bezel until the button clicks in place and fit the left end of the bezel onto the system.
Lock the bezel by using the key.
Figure 38. Installing the optional front bezel with the LCD panel
System cover
Removing the system cover
Prerequisites
Follow the safety guidelines listed in
Turn off the system, including any attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
Steps
Using a 1/4 inch flat head or a Phillips #2 screwdriver, rotate the latch release lock counter clockwise to the unlocked position.
Lift the latch till the system cover slides back and the tabs on the system cover disengage from the guide slots on the system.
Hold the cover on both sides, and lift the cover away from the system.
Safety
instructions.
Safety
instructions.
Installing and removing system components
83