Table of Contents
Advertisement
Slide the module out of the system.
Figure 113. Removing the VGA module
Next steps
Install the VGA
module.
Installing the VGA module
Prerequisites
Follow the safety guidelines listed in
Follow the procedure listed in
Remove the front
bezel.
Remove the backplane
cover.
Remove the air
shroud.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route these
cables properly when you replace them to prevent them from being pinched or crimped.
Steps
Route the VGA cable through the VGA module slot on the front of the system and slide the VGA module into the slot.
Align the hole on the module with the screw hole on the system.
Using the Phillips #1 screwdriver, secure the VGA module to the system with the screw.
150
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
