Dell EMC PowerEdge R640 Installation And Service Manual page 65

Option Description
Option
Family-Model-
Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores
Maximum Memory
Capacity
Microcode
SATA Settings
You can use the SATA Settings screen to view the settings of SATA devices and enable SATA and PCIe NVMe RAID mode on your
system.
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
Steps
Power on, or restart your system.
Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
On the System Setup Main Menu screen, click System BIOS.
On the System BIOS screen, click SATA Settings.
SATA Settings details
About this task
The SATA Settings screen details are explained as follows:
Option Description
Embedded SATA Enables the embedded SATA option to be set to AHCI Mode, or RAID Mode. This option is set to AHCI Mode
by default.
Security Freeze Enables you to send Security Freeze Lock command to the embedded SATA drives during POST. This option is
Lock applicable only for AHCI mode. This option is set to Enabled by default.
Write Cache Enables or disables the command for the embedded SATA drives during POST. This option is set to Disabled by
default.
Port n Enables you to set the drive type of the selected device.
For AHCI Mode or RAID Mode, BIOS support is always enabled.
Option
Model
Drive Type
Description
Specifies the family, model, and stepping of the processor as defined by Intel.
Specifies the brand name.
Specifies the total L2 cache.
Specifies the total L3 cache.
Specifies the number of cores per processor.
Specifies the maximum memory capacity per processor.
Specifies the microcode.
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Pre-operating system management applications 65