Figure 5-15 Hole Fill Assembly (2X) For Canopies With Six Holes Across North End - GE Giraffe OmniBed Service Manual

Chapter 5: Repair Procedures
e. If your canopy has six holes across the north end, install parts for the middle four holes as shown in
Figure 5-13 and install parts for the remaining two holes as shown in Figure 5-15. The parts for these
two holes serve to fill these two holes.
INSIDE OF
CANOPY
Smooth nut

Figure 5-15 Hole Fill Assembly (2x) for Canopies with Six Holes across North End

f. Snap the north seal vertically between the north spacer and canopy for a fit-check. Make sure that the
red/orange indicator is not visible from inside the canopy.
g. Using a 10 mm open-end wrench, tighten all smooth nuts.
CAUTION:
Do not over-tighten the hardware.
h. Remove the north seal.
82
Spacer washer
Flat washer
Canopy
6600-0343-000 104
Splitlock washer
M4x12 buttonhead
stainless steel screw
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
OUTSIDE OF
CANOPY