Figure 5-13 North Seal Parts; Figure 5-14 Beveled Side Of North Spacer Toward Canopy - GE Giraffe OmniBed Service Manual

INSIDE OF CANOPY
Beveled edge
5. Install north seal parts on the upside-down canopy:
a. Orient the north spacer with the beveled side toward the canopy edge, as shown in Figure 5-13 and
Figure 5-14.
Canopy
Smooth nut
INSIDE OF CANOPY
b. Start all set screws in the spacer, with the hex socket end of the screw pointing to the outside of the
canopy.
c. Add plastic spacer washers to the set screws.
d. Install the north spacer and washers to the canopy with smooth nuts.
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.

Figure 5-13 North Seal Parts

Spacer washer

Figure 5-14 Beveled Side of North Spacer Toward Canopy

Hex socket end
OUTSIDE OF CANOPY
Beveled edge North spacer
6600-0343-000 104
Chapter 5: Repair Procedures
Smooth nut
Canopy
North seal
Spacer washer
North spacer
M4x30 sockethead set screw
cup point
Set screw
Hex socket end
OUTSIDE OF CANOPY
81