Figure 5-12 Seal Cross-Section - GE Giraffe OmniBed Service Manual

Chapter 5: Repair Procedures
c. Thread the set screw into the threaded hole in the guide rail near the "E" or "W" inscription. Refer to
Figure 5-10. The socket of the set screw should be on the outside of the canopy.
INSIDE OF CANOPY
Canopy edge
d. At the middle position of the long canopy sides, install the longer screw, lockwasher, spacer washer,
gasket, door support, and smooth nut, as shown in Figure 5-10.
e. Slide the seals on both sides, for alignment purposes. Lift the seal assembly to the upper limit of the
canopy holes. Refer to Figure 5-12.
f. Using a 10 mm open-end wrench, tighten all nuts and screws until they feel snug.
g. Remove seal and verify that the lock washers are compressed flat. If necessary, tighten with 10 mm
open-end wrench and 2.5 mm hex key.
CAUTION:
Do not over-tighten the hardware.
h. Install and remove seals to check for easy installation.
80
Long lip of seal
Lift assembly to upper limit of canopy holes.

Figure 5-12 Seal Cross-section

6600-0343-000 104
Larger lobe
NOTE: The canopy
is upside-down.
OUTSIDE OF CANOPY
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.