Figure 5-17 South Corner Parts; Figure 5-18 North Corner Parts - GE Giraffe OmniBed Service Manual

Chapter 5: Repair Procedures
7. Install corner parts:
a. Using a Phillips screwdriver, install the corner pin, gasket, and corner receiver on the upside-down
canopy at each south corner (the corners opposite the heater door cutout). The corner receiver rib
should be closest to the canopy edge.
OUTSIDE OF
CANOPY
b. Using a Phillips screwdriver, install the corner pin, gasket, and corner flange on the upside-down
canopy at each north corner (the corners nearest the heater door cutout):
North flange corner
Canopy
Corner pin gasket
Corner pin
M4x16 flathead Phillips
screw with pre-applied
nylon patch
INSIDE OF CANOPY
c. Make sure that all pins point up. (The pins should point up when the canopy is upside-down, down
when the canopy is right-side up). Make sure all gaskets are on the inside.
8. Reinstall the canopy on the unit. This step may require the assistance of another person, as in Figure 5-6:
a. Using a 2 mm hex key, screw the set screws in the east and west rails at the E and W marks until they
are flush with the rails.
b. Turn the canopy right side up.
c. Insert the canopy north end, with the four set screws protruding, into the heater door bracket on the
unit.
d. Hold the canopy in place and hold the threaded inserts inside the canopy while using a 2 mm hex key
to install the three button head screws across the top of the canopy.
84
Rib

Figure 5-17 South Corner Parts

Figure 5-18 North Corner Parts

6600-0343-000 104
INSIDE OF
CANOPY
M4x16 flathead Phillips screw
with pre-applied nylon patch
Corner pin
Corner pin gasket
Canopy
Corner cover receiver
South corner cover
OUTSIDE OF
CANOPY
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.