Table of Contents
Advertisement
Chapter 4: Troubleshooting
Canopy up
Canopy middle
Canopy hand
switch up
Canopy hand
switch down
Canopy down
Bed down
pedal
Bed up pedal
Lists a chronological log of the last 8 system errors that occurred. Shows error number and date. It is
Errors
possible to clear the list.
Brings up a screen with 2 hour meters; one that is resetable and one that is not. To reset the resetable
Hours Run
hour meter, highlight CLEAR and push the control knob. The non-resetable hour meter will roll to 0 at
199,999.
Cal LV
Use to calibrate line voltage at the factory. To calibrate line voltage follow the procedure in section 3.4.
Use to enable or disable the patient temperature alarms in the manual mode (revision 1.40 and higher
Man temp al.
software only). If disabled on the service screen, it cannot be enabled on the user setup screen (wrench
icon). The alarm will not activate if a patient set point has not been entered.
In the event of a bed up/down or canopy pedal switch failure, selecting pedals allows the canopy to be
Pedals
raised or the bed to be raised or lowered (revision 1.6 software and higher).
BatLoad
Used for manufacturing only, not for service use.
Brings up humidifier calibration screen. Refer to "Chapter 3: Calibration and Maintenance" for information
Cal RH
on how this screen is used.
Brings up scale calibration screen. Refer to "Chapter 3: Calibration and Maintenance" for information on
Cal Scale
how this screen is used.
32
Heater doors open
Up
Status
Switches
Errors
Hours Run
Cal LV
Man temp al.
Pedals
BatLoad
Cal RH
ServO2
Cal Scale
LastCal: 1/1/02
Canopy pedal
Figure 4-4 Switch Diagnostic Diagram
Figure 4-5 Pedal Screen
6600-0343-000 104
Heater doors closed
37
c
Fri
3/3/03
10:10am
Humidifier reservoir
engaged
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Override control
Baby mode control
Increase control
Manual mode control
Decrease control
Air mode control
Boost air curtain
control
Humidifier
add water
Advertisement
Table of Contents
Troubleshooting
