Figure 5-4 Access Holes; Figure 5-5 Canopy, Bracket, And Heater Housing - GE Giraffe OmniBed Service Manual

Chapter 5: Repair Procedures
e. Using a 7 mm socket or wrench, remove and discard the nuts and star washers from the set screw
located on each side of the heater door bracket. Using a 2 mm hex key, remove and discard the two set
screws and the two spacers from the side seals. (Refer to Figure 5-2.)
Canopy Bracket
Access holes
Canopy mounting nuts
f. Support the canopy and hold the threaded inserts inside the canopy while using a 2.5 mm hex key
to remove the three button head screws across the top of the canopy. This step may require the
assistance of another person to support the canopy. Save all hardware from this step for reassembly
(the threaded inserts, three button-head screws, lock washers, and flat washers).
74

Figure 5-4 Access Holes

Heater Door Bracket

Figure 5-5 Canopy, Bracket, and Heater Housing

6600-0343-000 104
Housing bracket
Heater Housing
Canopy
Access holes
Button head screws
and threaded inserts
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.