Figure 5-56 Humidifier Parts - GE Giraffe OmniBed Service Manual

M3 x 12 Phillips head screw
(Attaches ground wire with
two star washers)
M3 x 10 socket
head cap screw
Star washer
Spacer
M3 x 10 Phillips
head coated screw
Add water thermostat
Safety thermostat
Split ring washer
6-32 Hex nut
Ramp block
Silicone tube
Steam outlet
Reservoir seal
12. Remove the 3 screws in the heater cartridge sheath.
13. To remove the heater cartridge, unscrew it from its threaded hole.
14. The thermostats can be replaced by removing the nuts securing them to the ramp block.
If either thermostat or the heater cartridge is being replaced, check all components (especially the plastic
ones) for signs of heat damage or corrosion. We recommend replacing the sheath when replacing the
heater cartridge.
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Reservoir switch
Top bracket
Top gasket
Heater cartridge
M3 x 10 Phillips head coated screw
Split ring washer
Heater mount
Heater cartridge sheath
Bottom gasket
Bottom bracket
Protective insert
Insulating cylinder

Figure 5-56 Humidifier Parts

6600-0343-000 104
Chapter 5: Repair Procedures
M3 x 16 Phillips head screw
Reservoir switch button
M3 x 8 Phillips head coated screw
135