Figure 54: The Location Of The Screw Holes On The Leg Assembly; Figure 55: Pillar To Leg Assembly - GE Lullaby Warmer Maintenance And Service Manual

Pillar to Leg Assembly and Height Adjustment (Continued)
Illustration
Lowest Height (880mm)

Figure 54: The location of the screw holes on the leg assembly

Figure 55: Pillar to Leg Assembly

Description
The bed can be adjusted to three desired heights,

Lowest Height (880mm).

Mid Height (950mm).

Top Height (1020 mm).
There is a difference of 70 mm between the consecutive heights.
Note: The height levels mentioned here are measured from the floor to the surface of the
mattress
WARNING: -
1.
Do not attempt to adjust the height of the bed after the hood and bed are fixed to the
base assembly.
2.
Always align the extreme screws before adjusting the middle one.
42 2042376-001 Rev G
Mid Height (950mm)
Handle
Pillar
©2012 General Electric Company. All rights reserved. Lullaby
Top Height (1020 mm)
Warmer
TM