OUTSIDE OF
CANOPY
6. Install south parts on the upside-down canopy:
a. Install the south guide rail with the four button head screws (2.5 mm hex key), washers, and lock
washers provided with the kit. Install all hardware finger-tight.
b. Slide seal on, for alignment purposes. Lift the seal assembly to the upper limit of the holes.
c. Tighten all nuts and screws until they feel snug.
d. Remove seal and verify that the lock washers are compressed flat. If necessary, tighten with 10 mm
open-end wrench and 2.5 mm hex key.
CAUTION:
Do not over-tighten the hardware.
e. Install and remove seal to check for easy installation.
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
INSIDE OF
CANOPY
Figure 5-16 South Seal Parts
6600-0343-000 104
Chapter 5: Repair Procedures
South seal
M4x16 buttonhead socket cap screw
M4 splitlock washer
South rail
Spacer washer
Canopy
Smooth nut
83