GE Giraffe OmniBed Service Manual page 129

10. Fasten the back panel to the display module with its 4 mounting screws.
11. Raise the elevating base to the highest position.
12. Fish a wire or string down through the lift rail and hook it to the upper hole in the tube on the door opening
assembly, then pull the tube up from the bottom of the lift rail until the lower hole in the tube lines up with
the small hole in the back of the lift rail. Push a hex key through the smaller hole in the lift rail into the lower
hole in the tube to hold the tube in place. Remove the wire. You may wish to tape the hex key in place so
that it cannot fall out during assembly.
13. Reconnect the heater door cable. Push the conical cap back through the hole in the front of the lift rail.
Reconnect the conical cap to the plastic tube by tightening the screw. Do not over-tighten the screw or you
may damage the plastic tube. Reinstall the access hole cover.
14. Secure the steel cable routing tube back in position with its 2 mounting screws.
15. Attach the door cable assembly to the bracket at the bottom upright. Position the top nut and flat washer
so the bottom of the flat washer is in the middle of the threads. Slide the threaded heater door opening rod
through the bracket, then install the flat washer, lock washer, and nut (8mm wrench).
16. Use a straight blade screwdriver in the slot at the cable rod's end to hold the rod and use the wrench to
tighten the bottom nut.
17. Install the upper end cap.
18. Slide the decorative strip up and install the bottom end cap.
19. Reinstall the right inside cover around the door cable with the 2 nuts and screws removed earlier.
20. Reinstall the heater housing cover and canopy soffit.
21. Release the intermediate rail locks by tightening the rail locking screws so the screw heads disengage from
the horizontal oblong holes in the uprights.
22. Reinstall the lift motor/gear box. In order to get the splines on the motor coupler to line up you may need
to push the lift rail into the upright to rotate the rail side coupler. Then reattach the motor/gear box to its
mounting plate with the 2 screws removed earlier.
23. Reinstall the connection panel at the bottom of the electrical enclosure. Fasten the controller cover to the
back of the enclosure.
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Chapter 5: Repair Procedures
6600-0343-000 104
101