Compartment Air Probe Repairs; Figure 5-48 Compartment Air Probe Disassembly - GE Giraffe OmniBed Service Manual

5.7 Compartment Air Probe Repairs

Refer to "Figure 5-48 Compartment Air Probe Disassembly".
Humidity
sensor
O-ring
Cylindrical spacer
Back panel
1. Using a 2.5 mm hex key, remove the screw that secures the probe cable clip to the back wall.
2. Remove the 2 screws (2mm hex key) that secure the probe housing cover and remove it.
3. Disconnect the connectors for the temperature and humidity sensor (if installed) wires and remove the
compartment air probe.
NOTE: Some early units have compartment air probes with jack connectors at the probe panel and should
be disconnected there. For these units you must order kit number 6600-0241-850 to replace the probe and
wire harness.
4. Feed the probe cable through the hole in the back wall and remove the front of the probe housing.
5. Remove the 4 screws in the break plate and remove the plate.
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Compartment air probe
Break plate
Probe cable clip

Figure 5-48 Compartment Air Probe Disassembly

Chapter 5: Repair Procedures
Probe housing cover
6600-0343-000 104
121