Removing The Old Harness From The Cable Carrier Channel; Installing The New Harness On The Cable Carrier Channel; Figure 5-38 Connector Drawing; Figure 5-39 Opened Cable Guard Latches - GE Giraffe OmniBed Service Manual

5.5.5.4 Removing the Old Harness from the Cable Carrier Channel

1. Open the first 4 exposed cable guard latches at the cable carrier channel end.
2. Unsnap the links with open covers leaving the end riveted link and 2 additional links on the cable carrier
channel.
3. Remove the 4 cable ties securing the harness to the channel. (Make note of routing and orientation).
4. Remove and discard the harness. You may want to save the cable carrier links to use as spares.

5.5.5.5 Installing the New Harness on the Cable Carrier Channel

1. On the replacement harness open the first 4 cable guard latches at the cable carrier channel end.
2. Remove the end link and the 2 adjoining links and set aside.
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
6600-1097-603
Connector
Blue P1
Green P2
Brown P3

Figure 5-38 Connector Drawing

Figure 5-39 Opened Cable Guard Latches

Chapter 5: Repair Procedures
6600-0343-000 104
109